Installation
Mounting the Unit
Mounting the Unit
Installation simply requires the physical mounting of the enclosure (using
the mounting holes provided, shown below) and connection of the power
and output lines.
.
Cable shielding
(if applicable)
1. Select the desired location
2. Mark the mounting holes (14 cm center to center, as shown) and drill
holes.
3. Prepare as required by surface (drywall anchors, etc)
4. Screw the unit into place using appropriate screws
5. Connect power and communication wires (through appropriate
conduit)
10
Installation
Overall width
15.6 cm
6 1/8"
14 cm
5½"
901T User Manual
Conduit