Honeywell IAQPoint2 Guide De Démarrage Rapide page 1530

Recommended Sensor Installation Heights
The installation heights recommended represent general guidelines.
Always confirm with local laws and regulations before proceeding, as
these take precedence over manufacturer's recommendations.
Detected Gas
CO Carbon Monoxide
*NO2 Nitrogen Dioxide
CL2 Chlorine
H2S Hydrogen Sulfide
O2 Oxygen
SO2 Sulfur Dioxide
R11 Refrigerants
R114 Refrigerants
R22 Refrigerants
R123 Refrigerants
R125 Refrigerants
R134A Refrigerants
R404A Refrigerants
R407C Refrigerants
R410A Refrigerants
R507 Refrigerants
COMB Most combustibles are heavier than air, with the exception of methane,
hydrogen,ethylene and acetylene. Sensors for gases that are heavier than
air should be installed approximately 30 cm (1 foot) from the floor. For
combustibles that are lighter than air, sensors should be installed 30 cm (1
foot) from the ceiling, close to the potential leak source.
* May differ in certain applications. Hot NO
Relative Density
(air = 1)
0.968
1.58 (cold)
2.50
1.19
1.43
2.25
5.04
5.9
3.11
5.27
4.14
3.52
3.43
3.0
3.0
3.43
from exhaust systems is lighter than ambient air.
2
301EM User Manual
Installation Instructions
Wall Mount Installation
Installation Height
1 - 1.5 m (3 - 5 ft.) from floor
30 cm -1 m (1-3 ft.) from ceiling
30 cm (1 ft.) from floor
30 cm (1 ft.) from floor
1 - 1.5 m (3 - 5 ft.) from floor
30 cm (1 ft.) from floor
30 cm (1 ft.) from floor
30 cm (1 ft.) from floor
30 cm (1 ft.) from floor
30 cm (1 ft.) from floor
30 cm (1 ft.) from floor
30 cm (1 ft.) from floor
30 cm (1 ft.) from floor
30 cm (1 ft.) from floor
30 cm (1 ft.) from floor
30 cm (1 ft.) from floor
11