Configuring A Sensor; Changer The Sensor Address - Honeywell IAQPoint2 Guide De Démarrage Rapide

Programming and Calibration

Configuring a Sensor

Configuring a Sensor
The Sensor menu option allows users to add a new sensor, to scan for
new sensors or to remove a sensor. Access the menu and use the arrows
to scroll to the Sensor menu and press enter to select.
There are now 4 possible actions available: NewSens?, Chg Adr., Scan
SD, Disable. Use the arrows to scroll up or down through these options
and press enter to select.
Note: The NewSens? menu is reserved for and should only be used
by qualified technicians.

Changer the Sensor Address

This menu lets users change the sensor's address (position) in the
301EM. Pay special attention when changing a sensor's address that you
do not change to an address that is already in use as this will replace the
existing sensor.
• Scroll to the Chg Adr. menu and press enter to select.
• The screen displays the sensor gas type, sensor # and its address.
Use the arrows to scroll through the sensors until the desired sensor
is displayed.
32 301EM User Manual