Setting The Unit's Address - Honeywell IAQPoint2 Guide De Démarrage Rapide

Setting the Unit's Address

The 301EM is shipped with the default address set to 1. If you are using
the unit in a network, this menu lets you select a specific address,
according to your network configuration.
• Access the menu and use the arrows to scroll to the Set Adr. menu
and press enter to select
• The Set Adr. menu is displayed. Use the arrows to change the
address and press enter when the desired address (Modbus
addresses M001 to M254 and Vulbus addresses V01 to V30) is
displayed.
• The screen returns to the main menu
Make certain that no two devices share an address as this
may result in network conflicts
301EM User Manual
Programming and Calibration
Setting the Unit's Address
31