Installation Instructions - Honeywell IAQPoint2 Guide De Démarrage Rapide

Installation Instructions

Wall Mount Installation
The recommended installation height is 1.5 m (5 ft) from the floor for
monitoring in offices or similar applications related to monitoring indoor air
quality.
For applications where health hazards are an issue, such as
facilities, the recommended installation height is 30.5 cm (1 ft) from the
floor.
1. Mount the bracket to the electrical box (using
standard electrical screws), as shown at right.
2. Connect wiring to terminal at back of unit.
3. Insert the tabs at the back of the IAQPoint into
the slots in the top of the mounting bracket, as
shown below.
4. Press the bottom of the IAQPoint into the
bottom of the mounting bracket, until it clicks
into place.
IAQ Point
5. If necessary, install locking screws in the holes provided at the base
of unit.
Note: The installation heights recommended by Honeywell Analytics
represent general guidelines. Always confirm with local laws and
regulations before proceeding, as these take precedence over
manufacturer's recommendations.
Mounting bracket
IAQPoint User Manual
Introduction
Installation Instructions
storage
CO
2
Electrical box
Mounting plate
CO
2
11