Function 2 - Activate Or Deactivate Service Mode; Function 3 - Search For A Network; Function 4 - Scan All Channels - Honeywell IAQPoint2 Guide De Démarrage Rapide

Using the Transmitter
How to Program the Transmitter

Function 2 - Activate or Deactivate Service Mode

Activating the Service mode means that LEDs will be functioning at all
times and not simply when programming. This will drain power from
the battery and have an impact on projected battery life.
• Press pushbutton 1
• Press pushbutton 2, count 3 blinks and release.
• Press pushbutton 1.
Once the command is activated, the transmitter will send "debug"
information to its communication port dedicated to service. It will also
display its network status via its LEDs.
Note: If either of the LEDs are blinking at regular intervals for more than
1 minute, the transmitter may still be in service mode. Simply
follow this procedure to deactivate service mode.

Function 3 - Search for a Network

Forces the transmitter to search for a network that is in Association
mode (see 301C manual for details), if the transmitter is not already
connected to a network.
• Press pushbutton 1
• Press pushbutton 2, count 4 blinks and release.
• Press pushbutton 1.

Function 4 - Scan All Channels

Forces the transmitter to scan on all channels for a network that is in
Association mode (see 301C manual for details), if the transmitter is not
already connected to a network.
• Press pushbutton 1
• Press pushbutton 2, count 5 blinks and release.
• Press pushbutton 1.
24
Functions 2 through 9 are for troubleshooting purposes
only and should not be used by unauthorized personnel.
Refer to Troubleshooting for details.
301W User Manual
Honeywell
511398
5/07