Using The 90Dm4; Programming Menus - Honeywell IAQPoint2 Guide De Démarrage Rapide

Programming Menus

The programming menus are available only when the 90DM4 is
equipped with its LCD screen option.
When the 90DM4 is first powered up, it must go through a warm up
cycle, which could take as long as 15 minutes. During the warm up
cycle, the LCD screen displays the device's address, the gas type and
"Warm Up".
When the device is in normal mode, it will display the device's address
and gas type on line one and concentration and unit of measurement on
the second line.
The programming menus provide access to a variety of function
screens. Each selection within the menu leads to another screen, in
sequence, until you have reached the end and can either Quit the
programming functions or continue to correct any input errors.
511105
2/07

Using the 90DM4

+02
680
Figure 4: Normal Display Screen
90DM4 User Manual
Honeywell
CO2
ppm
Using the 90DM4
Programming Menus
17