Using The Programming Menus; Main Menu Options List - Honeywell E3Point Manuel D'utilisation

Using the Programming Menus

The programming menus provide a series of options that let you
customize your gas detection system. Press the enter key to access the
programming menus. If no buttons are pressed for 2 minutes, the unit
exits programming mode to normal operation.
Caution
!
programming functions of this unit. Factory settings conform to specific
standards (see Specifications): any changes made to Alarm Levels may
affect manufacturer's stated standards compliance.

Main Menu Options List

Each of the menu options listed provides access to further sub-menus.
Consult the following pages of this manual for menu use instructions.
Menu Option
Network
Display
Relay
Buzzer
Alarm
Restore
Temp
SetZero
SetSpan
TestMode
Memory
Quit?
18
:
Only qualified, knowledgeable personnel should use the
Defines device address, baud rate, BACnet ID, or
communication protocol.
Provides a choice of discrete display.
Defines whether the relays will be latched, failsafe, or
activated.
Provides a choice between activated or silenced.
Allows configuration of various alarm levels.
Restores the device's factory configured calibration settings.
Sets the maximum temperature level.
Sets the sensor zero.
Calibrates the sensor span.
Simulates events for testing purposes without affecting sensor
readings (used during installation).
Reserved for authorized Honeywell Analytics technicians' only.
Exits the programming menus and returns the device to
normal operation mode.
Description
E Point Network Gas Monitor User Manual
3