Standard Parts List
Item #
1
E
Point cover
3
2
E
Point housing base
3
3
Main sensor assembly
4
Large rectangular J-box (not included)
5
Captive screw 10-32 x ½" (tamper-proof screw also available)
To change a sensor cartridge, disconnect all power to the device, pull
out the "smart sensor" cartridge, and press the replacement cartridge
into place. Be sure TOP/HAUT is toward the top of the unit. Once the
Smart Sensor is firmly in place, reconnect power. Use caution when
pressing the Smart Sensor cartridge into place to avoid bending the
pins.
Please see
section for special instructions for sensor changing gas types.
E
Point Network Gas Monitor User Manual
3
Figure 7. Parts of the E
Using the Programming Menus
Point
3
Description
in the Alarm Menu
33