Honeywell IAQPoint2 Guide De Démarrage Rapide page 45

IAQPoint2™
Configure\Configure Fieldbus\Set Address
If the BACnet protocol is selected, this screen facilitates setting the BACnet MAC
address from 1 to 127� If the Modbus protocol is selected, it facilitates setting the
Modbus ID from 1 to 247� The address must be unique within the segment�
Configure\Configure Fieldbus\Set BACnet ID
The BACnet ID can be adjusted to any value between 1 and 4,194,302 with the
numeric keyboard� The default value is 1� The Set BACnet ID menu applies only
if the BACnet protocol is selected� This number must be unique within the entire
network� A network may consist of multiple segments separated by routers� Values
from 0 to 4194302 may be entered�
Configure\Fieldbus\Set Parity
Parity value selections apply only to monitors configured with the Modbus
communications protocol� Even parity is the default�
This parity screen is available only if the Modbus protocol is selected� (BACnet
always uses no parity�) The monitor will use one stop bit unless the parity is set to
"none" in which case it will use two stop bits�
Configure\Configure Passwords & Reset\Set Password 1 or 2
Configure Password
Set Password 1
Set Password 2
Reset Configuration
Reboot
Password options are available through the Configure Passwords menu� The
Password Level 1, Password Level 2, and Reset to Factory Settings options are
described below� The Reboot option will force the monitor to shut down and then
restart�
This screen allows two passwords to be set� Passwords must be four digits long�
Configure\Configure Passwords & Reset\Reset all configuration
The Reset All Configuration option allows existing passwords to be deleted and
returns all of the monitor's options to the default values�
This function resets all user configuration information to factory defaults� This
includes setpoints, passwords, fieldbus configuration, and custom milliamp output
calibrations� The monitor will reboot after selections from this menu have been
made�
39