Fig. 15 :
Install a door fitting
Typical installation of a
profile cylinder
Fig. 16 :
Install a profile cylinder
EN
64
Installing the profile cylinder
The lock must be installed in the door before the profile cylinder can be installed („Installing the electric
security lock 809N", page 58, „Accessories", page 69). The profile cylinder must match the door leaf
thickness and the door fitting and protrude at least 3 mm from the door fitting when the door is
complete.
Install the profile cylinder as described in the accompany instructions. The following installation steps are typical:
1
Place profile cylinder in the profile cylinder cut-out (Fig. 16).
2
Fix it in place with the cylinder fixing screw.
3
Test the key for ease of movement.
You have installed the profile cylinder and can operate the lock with a key.
2.
2.
1.
2.
2.
6.
3.
4.
5.
4.
4.
1
1.
Installation