Installation; Notes; Installing The Passive Leaf Lock - Assa Abloy OneSystem Série Notice De Montage

Installation

Notes

A
Caution!
Functional limitation due to faulty recess of the lock pocket: The lock pocket
must be created corresponding to the lock pocket dimensions. You must insert
the lock without using any force and screw it into place, so that is not subject to
mechanical stress (Fig. 5 and Fig. 6).
Property damage after drilling through the lock: You may only use existing
holes drilled at the factory to attach fittings. The lock must be removed for any
work on the door leaf, such as drilling or cutting.
Damage from dirt: The lock can be damaged by dirt. The lock pocket and all
holes must be cleaned (by blowing out or vacuuming) prior to installation.
Functional limitation due to distorted installation: The lock must be installed
free of torsion.

Installing the passive leaf lock

Installation takes place with the ASSA ABLOY Easy-Installation assembly system.
ASSA ABLOY
For this purpose, a synthetic wire is pulled through each of the the bolt rods and
Easy-Installation
threaded in the lock case in the fastening position. Once the lock has been
assembly system
fastened in the door, the synthetic wire can be pulled in order to slide the bolt
rods to the fixing position and then the rods can be connected.
I
Note!
The bottom rod is optional: these steps need not be performed if there is no
bottom locking point.
EN 29
Installation