Intended Use - Assa Abloy OneSystem 809N Notice De Montage

Notices

Intended use

The electric security lock 809N is suitable for installation in single-leaf tubular frame or solid-leaf doors
(backset 55 mm or greater) made of metal, plastic or wood.
It is designed to provide door locking in security areas and is approved for use in emergency exit door
locks according to DIN EN 179 and panic door locks according to DIN EN 1125.
· With two-leaf escape doors, the inactive leaf must also be designed as an escape door and must be
equipped with a passive leaf lock („Accessories", page 69).
· If the inactive leaf is not designed as an escape door, the electric security lock 809N may only be installed
in the two-leaf door when the inactive leaf can be securely held in place with zero play and the active
leaf runs against a stop edge.
With double-leaf doors with rebated meeting stile and panic locks in each leaf, the leaf must open when
the panic door lock is actuated. Both leaves must open freely if both panic door locks are actuated at the
same time. This may require a door coordinator to be installed.
For double-leaf doors with rebated meeting stile and door closer, the correct door closing sequence must
be assured; otherwise the function of fire doors or smoke protection doors, in particular, is not guaran-
teed. It may be necessary to install a follower.
It is suitable for use on fire doors (smoke protection doors). All applicable provisions for the approval of
protective doors must be observed.
The electric security lock 809N is available in a special version without escape door function. This special
version is not permitted for use in escape doors according to DIN EN 179 and panic doors according to
DIN EN 1125. The special version is equipped with a continuous handle follower (continuous square
spindle). The inner and outer door handles are always engaged or disengaged simultaneously by an
electrical trigger action.
Since the lock is equipped with a door contact, only suitable striking plates may be used („Accessories",
page 69).
The electric security lock 809N may only be installed in properly functioning door systems. All applicable
regulations for the complete door system must be observed.
The device is suitable for installation according to the installation instructions and use according to the
functional description.
The electric security lock 809N is suitable for installation in doors with a high usage frequency, which entails
little occasion for care and thus there is a possibility of accidents or misuse (such as office doors).
It is not intended for any other type of use.
EN
45