!
Fig. 10 :
Adjust the panic side
EN
60
Changing the panic side
The panic side of a lock with escape door function („Escape door function/emergency exit and panic door
locks", page 41) must be adjusted before installation. The panic side of the lock must be adjusted so
that the door can be opened in the escape direction (normally outward from inside) with the door handle,
regardless of the locking status of the lock.
Warning!
An incorrectly adjusted panic side can result in life-threatening danger and risk of injury: After
installing the lock, check whether the locked door can be opened in the escape direction.
2,5 mm
1.
2.
The locking screws are always located on the panic side.
1
Press and hold the latch bolt.
2
Press the control latch.
3
Release the latch bolt while pressing the control latch.
The bolt is blocked.
4
Unscrew the locking screws (Fig. 10).
5
Re-insert the locking screws on the opposite side
(torque 2.5 Nm).
The panic function is now set on the opposite lock side.
Check the panic function using a latchkey and a spindle
(9 mm) before installing the lock.
Installation