Fittings; Lock Cylinders - Assa Abloy OneSystem 809N Notice De Montage

Fig. 12 :
Fittings and door handles
Fig. 13 :
Key withdrawal position
EN
62

Fittings

Outside
Disengaged side
A
LA
2
XF
LA
A
max.
30°
Electric security lock 809N with escape door
function
The electric multi-point lock 809N with escape door
function („Escape door function/emergency exit and
panic door locks", page 41) requires an escape door
fitting
· with split handle pin and
· door handle supported in the escutcheons for
Panic side
The length of the handle pin depends on
· the door leaf thickness,
· the horizontal lock position, and
I
· the necessary depth of engagement in the door
LI
The inner and outer handle pin are different and
usually identified with embossed letters. The
screw-on part of the handle pin must be mounted
on the inside.
Electric security lock 809N without escape
door function
The special version without escape door function
with door handles which can engage and disen-
gage on both sides requires a continuous, non-
XP
split handle pin.
LI
I

Lock cylinders

The length of the locking cylinder to be set is
determined from the door leaf thickness and the
inside and outside door plate thicknesses
(fittings).
The key withdrawal position (Fig. 13) of the
locking lever may not exceed 30° to the bottom
left or right.
max.
30°
rotation on both sides in accordance with DIN
EN 179.
handle (Fig. 12).
Installation