EN
72
Problem, cause, solution
The lock does not unlock
Problem
The lock can not be unlocked. Mechanical blockage
The lock does not lock
Problem
Although the door is closed,
the lock does not lock.
No reaction to control signal
Problem
The lock is not unlocked, even
though the unlocking control
input is activated.
Possible cause
Solution
The door leaf of the door frame is warped. The
deadbolt and latch bolt must be able to move
freely.
Possible cause
Solution
The rebate gap is too
Adjust a suitable rebate gap („Explanation
large, so the control
of terms", page 48 and „Technical data",
latch is not actuated by
page 67)
the striking plate.
Possible cause
Solution
The lock is also con-
During operation via the Hi-O Technology™
nected via the Hi-O
bus, e.g. with the IO module N5950 (separate
Technology™ bus.
instructions D00852), detach the gray connec-
tion cable on the functionless unlocking control
input.
The voltage has just
Wait 10 seconds after a restart until the lock is
been switched on on
ready for operation.
the lock.
Problem, cause, solution