Prepare the lock
Fasten the appropriate
striking plate
Fasten the locking
cylinder with the
cylinder fixing screw
Check for complete
functionality
Fig. 7 :
No transverse shear
stress on the bolt after
installation
EN
58
Installing the electric security lock 809N
1
Adjust the closing direction of the control latch („Adjusting the closing direction of the latch", page 59).
2
Adjust the panic side („Changing the panic side", page 60).
3
Fasten the electric security lock 809N in the lock pocket.
4
Fasten the lock fittings.
5
Check the electric security lock 809N for ease of movement.
Once the striking plate has been mounted, the electric security lock 809N is ready for use.
Mounting the striking plate
1
Finish the striking plate pocket and all holes or finish a customer-provided striking plate („Production
of customer-provided striking plates", page 66).
2
Clean the striking plate pocket and all holes by blowing them out or vacuuming.
3
Screw in the appropriate locking plate for the electric security lock 809N to be screwed in.
4
Check the electric security lock 809N for ease of movement.
The electric security lock 809N is ready for operation.
Installing fittings and locking cylinders
1
Install the fittings.
2
Insert the locking cylinder and ensure that the locking cylinder nose is in the centre position (Fig. 3).
3
Fix the locking cylinder into place with the fixing screw.
The electric security lock 809N is completely installed.
Testing the electric security lock 809N
1
Test all functions of the electric security lock 809N.
2
Check whether the latch and auxiliary latch bolt of the lock are pushed back by the same impact edge.
3
Check whether all bolts can freely extend and retract without transverse shear stress after installation
(Fig. 7).
The electric security lock 809N is completely installed and has been tested for functionality.
Striking plate
F
= 0
Q
N
min. 2
F
= 0
Q
N
Face plate
Installation