Mounting; Installing The Device; Installing The Electric Strike - Assa Abloy effeff 42130-10 Notice D'installation

I

Mounting

Mounting

Installing the device

7 Mount the unit on the wall with four screws near the door to be secured.
Make sure that none of the screws come into contact with conductive material,
for example the masonry reinforcement. This can lead to interference.
Distance between drilled holes:
Screw diameter:
Note!
Cable inlet housing wall or housing base: The cable inlet can be made through
three openings on the lower housing wall or in the housing base.

Installing the electric strike

1 Mount the electric strike to be controlled by the door code device
in the striking plate.
2 Mount the striking plate with the electric strike in the door frame.
Align the electric strike to the lock position so that the latch bolt rests
on the keeper with as little pressure as possible when the door is closed.
Excessive pre-load on the keeper can prevent release.
horizontal: 90 mm
vertical: 120 mm
4 mm
33
EN