Programming The User Code - Assa Abloy effeff 42130-10 Notice D'installation

User code
programming
EN
42

Programming the user code

For special applications, three additional codes – the so-called user codes –
can be programmed in the door code device 421-30-10. These codes are not
authorised for permanent unlocking and can be deleted again at any time.
In order to be able to address these codes individually during programming or
deletion, you must receive an index. This consists of the numbers "1", "2" or "3".
Example 2: The number sequence 4521 should be programmed as a second
user code.
1 Open the device with the key.
2 Press the programming button on the main
circuit board.
3 Activate index input.
4 Select index 2 for the new user code.
5 Finish the index input.
6 Enter the code digits.
7 Confirm the entry.
+
2
+
4 5 2
1
+
Configuration