Programming; Overview; Master Code; Entering And Exiting The Programming Mode - Assa Abloy ESA500 Manuel D'utilisation

Access code
I
EN
34

Programming

Overview

The following settings can be made in programming mode:
· assigning and deleting door codes,
· allocating rights,
· changing the release interval,
· change code length,
· changing the master code,
· activating and deactivating the permanent lock function,
· setting special functions (hotel and carrier function).

Master code

An individual master code (access and programming code) is already set in the
factory (page 94). The master code can be changed with a programming
function ("Table of function codes", page 38).

Entering and exiting the programming mode

Note!
Exit programming mode automatically: The programming mode is exited auto-
matically after 30 seconds with no inputs.
Switch on programming mode
99

Enter master code

Programming mode: active
Signal tone: with each push of a
button: (Fig. 1, page 35)
Switch off or cancel program-
ming mode
X X X
or
Wait 30 s
LED: 2x green
Programming mode: inactive
Signal tone: none when a button is
pushed
Normal operating mode: active
Programming