Deletion Of The User Code; Exit Programming Mode - Assa Abloy effeff 42130-10 Notice D'installation

Configuration

Deletion of the user code

1 Open the device with the key.
2 Press the programming button on the main
circuit board.
3 Activate index input.
4 Select the user code index.
5 Finish the index input.
6 Delete the user code.

Exit programming mode

The programming mode can be exited in different ways.
· If no keys are pressed on the keypad for fifteen seconds after the programming
mode is switched on, the programming mode is switched off and the previous
code is retained.
· If no other key is pressed for four seconds after entering at least two digits
in programming mode, the programming mode is also switched off and the
previous code is overwritten.
· If you press the key
the new code is accepted and the programming mode is switched off.
· If programming is to be aborted (e.g. due to an input error), this can be achieved
by pressing the key
adopted, the previous code will remain valid. The programming mode is thus
switched off and must be reactivated if necessary.
· If the maximum possible number of digits (six digits) is reached when a code
is programmed, the code is adopted and the programming mode is
automatically switched off.
after entering all digits of a code to be programmed,
+
. The previously entered code digits will then not be
−
+
1 2 3
, or
+
−
EN
43