B2.3 Powering On; B2.4 Basic Settings - Nanosonics trophon EPR Mode D'emploi

Figure 8

B2.3 Powering On

1. Attach the power cable supplied to the trophon power socket.
2. Connect to mains power and switch on.
3. Turn on the power switch, located on the side of the trophon.
NOTE: To maximise the life of the disinfectant cartridge, keep your trophon switched on at all
times, except when the machine needs to be moved.

B2.4 Basic Settings

For all settings:
1. Press the soft key underneath Menu on the screen.
2. Using the soft keys under the LCD:
 Scroll to Setup and press OK.
 Press OK after each setting has been made.
Date and Time
 Scroll to Set Date and Time and follow the onscreen messages.
Language
 Scroll to Language and follow the onscreen messages.
Alarm Settings
 Scroll to Alarm Settings and press OK.
 Change the alarm repeat or volume settings by following the onscreen messages.
 If alarm repeat is enabled, the alarm will repeat every 30 seconds for the following
situations:
a. The probe is left in the trophon after a HLD cycle.
b. An error message is displayed and requires a response.
Contrast
 Scroll to Contrast and follow the onscreen messages.
L00049 5.0 03/2017
Figure 9
10