B2.2 Powering On; B2.3 Initial Setup; B2.4 Warm Up Cycle; B2.5 Trophon2 Touch Screen - Nanosonics trophon 2 Mode D'emploi

B2.2 Powering On

The trophon2 must not be connected to the same circuit as a critical patient or life support
device.
1. Attach the power cable supplied to the trophon2 power socket.
2. Connect to mains power.
3. Turn on the power switch, located on the left side of the trophon2.
NOTE: To maximise the life of the disinfectant cartridge, keep your trophon2 switched on at all times,
except when moving the device.

B2.3 Initial Setup

The Initial Setup launches automatically, prompting you to configure the optional settings when
turning on the trophon2 for the first time. Follow the on screen instructions.

B2.4 Warm up Cycle

1. The warm up cycle prepares the trophon2 for operation and will begin automatically when the
machine is powered on.
2. The screen message will indicate when the trophon2 is ready for use. Follow the on screen
instructions.

B2.5 trophon2 Touch Screen

The trophon2 is operated using the touch screen User Interface (UI).
NOTE: The UI can be used with gloves.
Cleaning the trophon2 Touch Screen
The screen can be wiped clean using a soft, nonabrasive and lint-free cloth or wipe.

B2.6 Basic Settings

The available settings are:
Sleep timer: The default inactive period until the trophon2 enters sleep mode is two hours, which
can be adjusted in this setting.
Language
Date
Time: For record accuracy, user must set the timezone in this setting in addition to the time.
Printer label
Daily timers: Configure a preset daily wake and sleep time
Brightness and Alarm
Network
To access:
1. Select Menu

2. Select the required setting and follow the on screen prompts.
®

B2.7 AcuTrace

AcuTrace is an automated HLD traceability system that incorporates Radio Frequency Identification
(RFID). AcuTrace enabled accessories and consumables contain RFID chips that store digital
information and can be read by the in-built AcuTrace reader.
L03072 2.0 04/2020
Settings
13