B2.8 Acutrace® Settings; Section B3: Trophon Acutrace ® Plus; B3.1 Activation; B3.2 Network Parameters Setup - Nanosonics trophon 2 Mode D'emploi

®
B2.8 AcuTrace Settings
AcuTrace features can be enabled or disabled via the trophon2 menu. Press:
1. Menu AcuTrace

2. Select the required setting for update and follow the on screen prompts.
SECTION B3: trophon AcuTrace
trophon AcuTrace PLUS allows trophon2 to connect to Hospital Information Systems for automated
sharing and centralised storage and processing of disinfection data and enables Parametric Release.

B3.1 Activation

trophon AcuTrace PLUS will be prompted during the Initial Setup and can be activated through the
product trophon AcuTrace PLUS Activation Card. Follow the on screen instructions during the initial
setup.
To activate after initial setup, select:
Menu AcuTrace
 
Follow the on screen instructions.

B3.2 Network Parameters Setup

Consult your facilities IT administrator or network parameters expert to complete this setting.
The device supports the TCP/IP protocol. Set the IP address using the Dynamic Host Configuration
Protocol (DHCP) or a static configuration, select:
Menu Settings Network
 
When configured using DHCP, the device will be assigned a valid IP address from the router.
To set the IP address with the static configuration, please check prior with a network administrator to
ensure that the IP address is not in use and advise the appropriate values for the subnet mask and
the default gateway.
PART C – OPERATION

SECTION C1: Loading the Disinfectant Cartridge

The cartridge door opens automatically, DO NOT force open.
A trophon2 disinfectant cartridge needs to be inserted into the trophon2 before a HLD cycle can
commence.
Refer to the disinfectant IFU for detailed instructions on how to scan and log, insert, or remove
disinfectant cartridges.
Inserting a Disinfection Cartridge
The trophon2 screen will automatically prompt to scan (if AcuTrace is enabled) and insert a new
disinfectant cartridge, when required. Follow the on screen instructions and refer to the
disinfectant IFU.

SECTION C2: Logging the trophon Chemical Indicators

No other chemical indicators are approved for use in the trophon2.
If AcuTrace is enabled, log the new batch of Chemical Indicators by selecting:
1. Menu AcuTrace

2. Follow the on screen instructions.
L03072 2.0 04/2020
Workflow.

®
PLUS
AcuTrace PLUS
Log Chemical Indicators.

15