Preliminary Hardware Settings - ero electronic TKS Manuel De Service

PRELIMINARY PRELIMINARY PRELIMINARY PRELIMINARY PRELIMINARY HARDWARE HARDWARE HARDWARE HARDWARE HARDWARE SETTINGS SETTINGS SETTINGS SETTINGS SETTINGS
How to remove the instrument from its case How to remove the instrument from its case How to remove the instrument from its case How to remove the instrument from its case How to remove the instrument from its case
1) Switch off the instrument.
2) Push gently the lock A on the right.
A
3) While the lock A is maintained out, slide out the right side of
the instrument.
A
4) Push gently the lock B on the left.
5 ) While the lock B is maintained out, slide out the
instrument.
B
XKS-1-B0.pmd 6
MAIN INPUT SELECTION MAIN INPUT SELECTION MAIN INPUT SELECTION MAIN INPUT SELECTION MAIN INPUT SELECTION
If an input different from TC-RTD input (standard) is desired,
remove the instrument from its case and set J1 according to
the following table.
INPUT J1
TYPE 1-2 3-4 5-6
TC-RTD open close open
60 mV open close open
5 V close open close
10 V open open close
20 mA open open open
NOTE NOTE NOTE: the jumper not used can be placed on pin 7-9
NOTE NOTE
2 4 6 8 10
J1
1 3 5 7 9
GB GB GB GB GB 6
20/06/2005, 11.08
7-8 9-10
open open
open open
open open
open open
close close
Fig. 11