Alloy Frame - Speacialized Turbo Levo Manuel Utilisateur

10.9
Fig. 10.9: Install the non-drive side motor cover. Torque the bolts to 9.5 in-lbf / 1.0 Nm.
„
Install the dropper post, shift and brake systems according to the manufacturer's instructions.
„
Reinstall the rear shock (Forward shock eye: 90 in-lbf / 10.2 Nm, Extension @ Link: 180 in-lbf / 20.3 Nm).
„
Follow the same steps as for the carbon frame. The two frames differ only in how the housings are routed
„
through the head tube ICR port and the side-arm. The different steps are listed below.
10.10
Fig. 10.10: Insert the side-arm housing guide with nylon tubes into the side-arm, until the nylon tubes exit at the
„
motor cavity.
Install the shift, brake and dropper post housings into the head tube ICR port, guide them out the exit port above
„
the forward shock mount, then guide the housings into the holes in the side-arm guide.
Install the two cable bats into the side-arm to hold the housings in place. Torque to 9.5 in-lbf / 1.0 Nm.
„
27

10.2. ALLOY FRAME

DERAILLEUR
BRAKE
FRAME WIRING
DROPPER POST