Speacialized Turbo Levo Manuel Utilisateur page 25

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 39
9.8
Fig. 9.8: Once all pivot locations are assembled and torqued to specification, torque the lower shock eye bolt.
For easy lower shock eye bolt access, use the Carbon Crank 6mm Allen w/Socket, part
#9891-3010.
All models are assembled with the Flip Chip in the Low position. Switching to the High position
raises the bottom bracket height by approximately 5-6mm and steepens the head tube angle by
approximately 0.5 degrees.
Place a rag between the link and the seat tube to make sure the link doesn't make contact with the
seat tube.
Remove the upper shock eye bolt and the two extension bolts, then remove the extension/shock assembly from
the bike.
Remove the lower shock eye bolt, then remove the Flip Chip halves out of the lower shock eye.
Rotate the Flip Chip halves 180 degrees then push them back into the lower shock eye.
Assemble the rear shock eye to the extension and install the bolt (do not torque at this time).
Install then torque to specification the upper shock eye bolt and the two extension bolts.
Torque the lower shock eye bolt to specification.
LOWER SHOCK EYE BOLT
FLIP CHIP
22

Publicité

Table des Matières
loading

Table des Matières