Removing And Installing The Battery - Speacialized Turbo Levo Manuel Utilisateur

8.3
REMAINING
CHARGE %
90-100
80-89
70-79
60-69
50-59
40-49
30-39
20-29
10-19
0-9
CAUTION: Installation or removal of the battery should be done with the bike on a repair stand
so the battery can slide out at the bottom. Alternatively, if a repair stand is not available, the bike
can be carefully placed on its side or turned upside down. If placed on its side, the bike should be
on even ground and leaned towards the non-drive side. Due to its increased weight, turning the
bike upside down may require more effort than with a regular bike. Be careful not to damage any
components when turning the bike over and place it on soft ground or protective material.
8.5
0-9
Fig. 8.5: Unscrew the bolt under the down tube.
„
Fig. 8.5: Grab the pull handle and pull the battery down out of the frame.
„
Reverse the steps to reinstall the battery. Torque the bolt to 55 in-lbf / 6.2 Nm.
„

8.4. REMOVING AND INSTALLING THE BATTERY

8.4
REMAINING
CHARGE %
0-9
14