Speacialized Turbo Levo Manuel Utilisateur page 29

10.7
Fig. 10.7: Insert one end of the dropper post housing between the motor and the frame, on the non-drive side of
„
the Shadow Loop, then guide the housing up the side-arm, top tube, and out the head tube area (A).
Fig. 10.7: Insert the other end of the dropper post housing between the motor and the frame, on the drive side of
„
the Shadow Loop, then guide the housing up the seat tube until it exits the top of the seat tube (B).
Fig. 10.7: Make sure the housing is positioned underneath the Shadow Loop protrusion (C), then grab both ends
„
of the housing and push/pull in both directions to ensure the housing can move freely.
Fig. 10.7: Guide the brake and shift housings into the nylon tubes until they exit the head tube exit port (Fig. 10.8).
„
10.8
Fig. 10.8: Guide the dropper post housing out the upper drive side exit port hole.
„
A B
C
A
B
26