Ordering Spare Parts; Disposal And Environmental Protection - Tractel tirak L 500 P Série Manuel D'installation Et De Manutention Original

Operation and Installation Manual
If the load limiting device does not react:
– Remove the blanking plug (1).
– Loosen the lock nut (5) with the socket wrench.
– Insert a screwdriver into the setting screw (3).
– Screw in the setting screw (3) until the load limiting device
reacts.
– Lower the overload to the ground.
– Raise the overload again.
The load limiting device must react. Otherwise repeat the
procedure.
The load limiting device must not react when the hoist is loaded
to the maximum working load.
– Load the load lifting equipment with the maximum working
load.
– Raise until the load lifting equipment hangs freely.
The load limiting device must not react when lifting the load.
If the load limiting device reacts:
– Lower the load to the ground.
– Insert a screwdriver into the setting screw (3).
– Screw the setting screw (3) out by one half turn.
– Raise the load again.
The load limiting device must not react when lifting the load.
If setting screw (3) was adjusted, repeat the test with the maxi-
mum overload.
– Load the load lifting equipment with the calculated overload.
– Raise the load.
The load limiting device must react and stop the UP travel of
the hoist within the first 10 cm.
– Tighten the lock nut (5) with the socket wrench.
– Replace the blanking plugs (1) and secure with red sealing
wax.

15.6 Ordering spare parts

Spare parts lists can be obtained from your supplier or directly
from TRACTEL Greifzug GmbH.
The details needed to place the order are listed on the separate
component's nameplates, see 'Nameplate and warning signs /
application restrictions' on page 7.
The required information is e.g.:
Rope drive: Article no., tirak™ model / Tractel
rope diameter, serial number
EN-24
Motor:
Brakes:
Electrical con-
trols:
Wire ropes:
16 Disposal and environmental
protection
The equipment is made from recyclable materials. If the equip-
ment is later scrapped, it must be disposed of correctly. The
national versions of the waste legislation directive 2008/98/EC
apply within the European Union.
– Dispose of operating materials and cleaning agents in ac-
cordance with the national regulations applicable in the
country of operation.
– Abide by the safety instructions given by the manufacturer
of the operating materials and cleaning agents used.
– Dispose of equipment or components without operating
materials in accordance with the national regulations.
The manufacturer is obliged to take back and dispose of specific
electrical and electronic components in accordance with Directive
2002/96/EC. The following symbol is used on the nameplate of
such components to identify them:
model,
®
Article no., Motor model
Article no., Type and coil voltage of the
brake
Number of the circuit diagram
Rope diameter, construction, length, packing
G1035.2 - 11/2014