Changing The Saw Blade; Replacing The Plastics Insert; Replacing The Recuperating Spring; Transport - ATIKA BWS 400-2 Notice Originale

Maintenance

Changing the saw blade

Remove the mains plug before changing the saw blade.
Danger of cutting! The saw blade is massive and it could be to
slick. Wear gloves when replacing the saw blade.
 Do not use any saw blades made of HSS steel.
 Do not use any cracked saw blades or such that have changed
their shape.
 Only use well-sharpened saw blades.
Danger of burning! The saw blade is still hot shortly after cutting.
Unscrew the limit blade (3).
Loosen the locking plate (13).
Remove the cotter pin (16c) and the washer (16d).
Remove one end of the safety chain (10).
When doing so, firmly hold the tilt table.
Slowly lower the tilt table (7) towards the ground.
Bolt down the outside saw blade cover (2).
Loosen the locking nut M20x1.5 with the open-end wrench (25)
and the ring spanner (26).
Now, the front saw blade flange (23) and the saw blade (22) can be
removed.

Clean the saw blade flanges (23, 21).
Install a new or sharpened saw blade (22).
Pay attention to the correct running direction of the
saw blade: The arrow on the saw blade and the arrow
on the saw blade casing must point in the same
direction!
Position the front saw blade flange again
The further assembly is now done in reverse sequence.
Re-attach the locking plate (13).

Make sure after mounting that everything is tightened firmly.

Replacing the plastics insert

Immediately replace the worn or damaged plastics inserts
(24).
Loosen the screws of the plastics insert and remove them.
Insert a new plastic insert and screw it tightly in place.

Replacing the recuperating spring

Immediately replace a worn or damaged recuperationg
spring
Loosen the locking plate (13).
Remove one end of the safety chain (10).
When doing so, firmly hold the tilt table.
Remove the cotter pin (16c) and the first washer (16d) and pull out
the bolt (16a) from the bracket.
Slowly lower the tilt table (7) towards the ground
Remove the second washer and the recuperating spring
(16b).
Slide a new recuperating spring and washer on the recuperating
bolt (16a)
The further assembly is now done in reverse sequence.
Re-attach the locking plate (13).

Make sure after mounting that all screws are tightened firmly.

Transport

Remove mains plug before each transport.

Storage

Pull out power plug
 Store unused equipment in a dry, locked place out of the reach of
children.
 Before a longer period of storage carry out the following to extend the
saw service life and ensure an easy operating:
 thoroughly clean the device
 treat all movable parts with an environmentally friendly oil

Never use any grease!

Guarantee

Please observe the enclosed terms of guarantee.
17