Maintenance And Cleaning; Changing The Saw Blade - ATIKA BTU 450 Notice Originale

Using the movable cross stop
Connecting a chip extractor
Chip ejector slot closed (operation with chip extractor)
A chip extractor can be connected to the saw to extract the chips. (Diameter
of extractor nozzle: 100 mm.) Close the sealing blade on the chip ejector slot
and secure it using the machine knob.
Chip ejector slot open (operation without chip extractor)

Maintenance and cleaning

Before each maintenance and cleaning work
− Switch off device
− Wait unitl the saw blade comes to a stop.
− Pull out power plug
Maintenance and repair work other than those described in this chapter is
only allowed to be carried out by service staff.
For maintaining and cleaning, removed security devices must unconditionally
be mounted properly and proved again.
Use only original parts. Other parts can result in unexpected damages and
injuries.
Cleaning
Observe the following to maintain the operability of the machine:
Do not wash down device with water.
Remove shavings and dust only with a brush or vacuum cleaner.
Regularly clean and oil all movable parts (e.g. fasteners of the guard).
Fig. 10
Never use any grease!
Use for instance sewing machine oil, liquid hydraulic fluid or
environmentally acceptable spray oil.
Take care that the saw blade remain free of rust and resin.
Resin residues must be removed from the table board.
Resin residues can be removed with a commercial maintenance
and care spray.
The saw blade is a wearing part and will become dull after prolonged or
frequent use.
Renew the saw blade or have it sharpened
Maintenance

Changing the saw blade

Remove the mains plug before changing the saw
blade.
Danger of cutting! The saw blade is massive and it could be to slick.
Wear gloves when replacing the saw blade.
Do not use any saw blades made of HSS steel.
Do not use any cracked saw blades or such that have changed their
shape.
Saw blades the body of which is broken must be discarded (no repair
allowed).
Only use well-sharpened saw blades.
Regrinding (sharpening) of saw blades is only allowed to be done by
qualified personnel. In particular note the following: Make sure that the
requirements for balancing of the tools according to EN 847-
1:2005+A1:2007 6.2.3.2 are met.
Danger of burning! The saw blade is still hot shortly after cutting.
1. Fold the safety guard backwards.
2. Loosen the screws of the table insert and move it back.
.
16