Replacing The Table Insert; Transport; Storage; Guarantee - ATIKA BTU 450 Notice Originale

3. Insert rod (33) into motor-shaft and unscrew bolt (
4. Now, the front saw blade flange (27) and the saw blade (26) can be
removed.
5. Clean the saw blade flanges.
6. Install a new or sharpened saw blade.
Pay attention to the correct running direction of the saw blade: The
arrow on the saw blade and the arrow on the protective cover must point
in the same direction!
7. Position the front saw blade flange again.
8. Re-tighten the clamping nut (28).
9. Secure the table insert.
10. Fold the safety guard back to its original position.

Replacing the table insert

Disconnect the mains plug before changing the table
insert.
Immediately replace a worn or damaged table insert.
1. Fold back the safety guard (15).
2. Loosen the screws of the table insert (6) and move it back.
3. Remove the 2 nuts (a) and remove the blade guard (12) together with the
safety guard.
4. Install a new table insert (6).
5. Secure the blade guard with the safety guard (for blade guard adjustment
see figure 13).
6. Secure the table insert.
7. Fold the safety guard back to its original position.
17
Blade guard adjustments
The adjustment of the blade guard must be checked after each saw blade
and table insert change.
left-hand-thread)

Transport

Storage

Store unused equipment in a dry, locked place out of the reach of children.
Before a longer period of storage carry out the following to extend the saw
service life and ensure an easy operating:

Guarantee

Please observe the enclosed terms of guarantee.
Before each transport:
− Switch off device
− Wait unitl the saw comes to a stop.
− Pull out power plug
− Accessories such as stops must be securely
mounted or clamped on the machine.
Pull out power plug
− thoroughly clean the device
− treat all movable parts with an environmentally friendly oil
Never use any grease!