Stihl FSA 200.0 R Notice D'emploi page 23

12 Bluetooth® Radio Interface
1
2
3
1 A short beep
The acoustic signal works as it should.
2 Four or six (AR L) long beeps
The battery's charge is low. Recharge the
battery.
3 Rapid succession of short beeps
There is a malfunction in the battery. The sig‐
nal stops automatically after a few seconds.
Do not attempt to charge, use or store the
battery. Replace the battery.
These LEDs can glow or flash green or red.
If one LED glows red continuously: the
battery is either too hot or too cold.
Allow the battery to warm up or cool
down gradually at an ambient tempera‐
ture of about 50 °F to 68 °F (10 °C to
20 °C).
If the four right side LEDs flash red and
a rapid succession of several short
beeps is emitted: the battery has a
malfunction and must be replaced. Do
not attempt to charge, use or store the
battery.
► Be aware that your ability to hear the acoustic
signal may be reduced when wearing hearing
protection.
11.2.2 Power Tool Status
When the battery is connected to the power tool,
the same LEDs on the battery will indicate the
status of the power tool.
If three LEDs glow red continuously: the power
tool motor is too hot. Allow the motor to cool
down.
If three LEDs flash red when you activate the
trigger switch: the power tool has an electrical
malfunction. Do not operate the power tool. Have
it checked by an authorized STIHL servicing
dealer before use or storage.
For troubleshooting information,
11.2.3 Charge Status
The LEDs and acoustic signals on the battery
also indicate the battery's state of charge.
0458-041-8201-A
To determine the battery's state of charge:
.......
► Press the button (1) on the backpack battery.
A single short beep will be emitted. The LEDs on
the battery will glow or flash green for about
5 seconds indicating the state of charge (see
illustration).
For example:
If six green LEDs glow continuously: full charge.
If one green LED is flashing and four long beeps
are emitted: less than 20 % charge.
12 Bluetooth® Radio Interface
12.1
► Press and hold the push button for about
3 seconds.
If the Bluetooth
symbol glows blue for about 3 seconds, the
battery's Bluetooth
12.2
► Press and hold the push button for about
3 seconds.
If the Bluetooth
the Bluetooth
12.3
Resetting the battery to the factory setting means
that all user-specific data will be deleted.
► Press the push button four (4) times in quick
succession and keep it pressed on the fourth
time until the "BLUETOOTH®" LED next to
the
25.
► Then release the push button immediately.
► Connect the battery to the STIHL connected
App to confirm that all user-specific data has
been deleted.
100 %
Turning the Bluetooth
face On
®
LED next to the connected
®
interface is on.
Turning the Bluetooth
face Off
®
LED flashes blue six times,
®
interface is off.
Resetting the Battery to Fac‐
tory Settings via Bluetooth
(AP 300 S and AP 500 S only)
symbol flashes blue.
English
0 %
Inter‐
®
Inter‐
®
®
23