Publicité
Les langues disponibles
Les langues disponibles
depends on the water hardness level set on the
appliance.
The descaling procedure can also be performed
whenever the user desires a deeper cleaning of the
internal steam circuit.
Before to run the descaling phase, the appliance will
check if some residual water is contained into the
boiler, and a Drain cycle could be performed, if
needed. In this case, you will have to empty the
drawer after the Drain cycle, before continuing with
the Descale Phase.
Please note: to ensure that the water is cold, it is not
possible to perform this activity before 30 minutes have
elapsed from the last cycle (or the last time the product
was powered). During this waiting time, the display will
show the following feedback "WATER IS HOT".
»
PHASE 1/2: DESCALING (70 MIN)
When display will show <ADD 0.25 L OF SOLUTION>,
please pour the descaling solution in the drawer. For
best results in descaling, we recommend filling the
tank with a solution composed of 75 g of the specific
WPRO product and 250 ml of drinking water. WPRO
descaler is the suggested professional product for the
maintenance of the best performance of your steam
function in the oven. For orders and information
contact the after sales service or www.whirlpool.eu.
Whirlpool will not be held responsible for any
damage caused by the use of other cleaning products
available on the market.
250 ml
Once the descaling solution is poured inside the
drawer, press
to start the main descaling process.
The descaling phases do not need you to stay in front
of the appliance. After each phase is completed, an
acoustical feedback will be played and the display
will show instructions to proceed with the next
phase.
Once the descaling phase has been completed, the
boiler will be drained: the descaling solution used
during this phase will be poured into the extractable
drawer.
PHASE 2/2: RINSING (30 MIN.)
»
To remove descale residuals from the drawer and
the steam circuit, rinse cycle has to be done. When
display shows <ADD 0.25 L OF WATER> fill the tank
with 0,25 L of drinking water, then press
the rinsing. Do not turn off the oven until all the steps
= 75 g
1
+
2
+
3
required by the function have been completed.
Please note: if needed from the system, it could be
requested to emty the drawer and to repeat this
operation.
When Descale procedure is completed, it is suggested
to dry the cavity from potential water residuals. It will
be then possible to use all the steam functions.
Please note: during the Descale cycle, some noise
could potentially be heard since the oven pumps are
activated in order to guarantee the optimal descale
efficiency.
Once the maintenance cycle has started, do not remove
the drawer unless requested by the appliance.
Please note: After the boiler gets filled by the descaling
solution and the display shows "DESCALING PHASE
1/2", the cycle should not be interrupted, otherwise the
entire descaling cycle must be repeated before being
able to run any steam function.
. MINUTEMINDER
To activate this function press the
or
to set the length of time you require and then
press
to activate the timer.
MINUTE-MINDER
An audible signal will sound and the display will
indicate once the minuteminder has nished counting
down the selected time.
Please note: The minuteminder does not activate any of
the cooking cycles.
The minute minder can be activated also when a
function is running.
The timer will continue to count down independently
without interfering with the function itself.
During this phase, it isn't possible to see the
minuteminder (only the
will continue counting down in background. To edit the
minuteminder you can press the
time using the
To cancel the minuteminder, press the
select
con rm.
. KEYLOCK
To lock the keypad, press and hold
five seconds. Do this again to unlock the keypad.
KEYLOCK
Please note: This function can also be activated during
cooking. For safety reasons, the oven can be switched
off at any time by pressing
to start
icon will be displayed), that
or
icon.
until the time displayed is "--:--". Press
.
icon. Press
icon and set the
icon, then
to
for at least
Publicité
