Publicité
Les langues disponibles
Les langues disponibles
indications, extract the drawer, open drawer's lid and
fill it with water until the level requested on the
display. Close the drawer by pushing it carefully
towards the panel until completely closed. After the
drawer insertion, press START to proceed with the
cooking cycle. The drawer must always remain closed,
except for water filling.
After the first filling, in case of longer cooking cycles,
once water will have ran out, it could be necessary to
add it again, in order to complete the cycle: the oven
will prompt it in case it is needed.
3. START THE FUNCTION
At any time, if the default values are those desired or
once you have applied the settings you require, press
to activate the function.
During the delay phase, by pressing
will ask if you want to skip this phase, starting
immediately the function.
Please note: Once a function has been selected, the
display will recommend the most suitable level for each
function. At any time you can stop the function that has
been activated by pressing
If the oven is hot and the function requires a specific
maximum temperature, a message will shown on the
display. You can either select a different function or
wait for a complete cooling.
4. PREHEATING
Some functions have an oven preheating phase: Once
the function has started, the display indicates that
the preheating phase has been activated.
PREHEATING
Once this phase has finished, an audible signal will
sound and the display will indicate that the oven
has reached the set temperature, requiring to "ADD
FOOD". At this point, open the door, place the food in
the oven, close the door and start cooking by pressing
or
.
the oven
.
Please note: Placing the food in the oven before
preheating has finished may have an adverse effect on
the final cooking result. Opening the door during the
preheating phase will stop pause it.
The cooking time does not include a preheating
phase. You can always change the temperature you
want the oven to reach using
5. TURN OR CHECK FOOD
Some 6th Sense functions will require the food to be
turned during cooking.
TURN FOOD
An audible signal will sound and the display shows
the action to be done. Open the door, do the action
prompted by the display and close the door, then
press
to continue cooking.
In the same way, at 10% of time before the end of
cooking, the oven prompts you to check the food.
CHECK ON FOOD
An audible signal will sound and the display shows
the action to be done. Check the food, close the door
and press
or
Please note: Press
if no action is done after a certain time the oven will
continue the cooking.
6. END OF COOKING
An audible signal will sound and the display will
indicate that cooking is complete.
END
Press
to continue cooking in manual mode
(untimed) or press
by setting a new duration. In both cases, the cooking
parameters will be retained.
BROWNING
Some functions of the oven enable you to brown
the surface of the food by activating the grill once
cooking is complete.
PRESS v TO BROWN
When the display shows the relevant message, if
required press
to start a five-minute browning
cycle. You can stop the function at any time by
pressing
to switch the oven off.
. FAVORITES
Once cooking is complete the display will prompt you
to save the function in a number between 1 and 10
or
.
to continue cooking.
to skip these actions. Otherwise,
to extend the cooking time
Publicité
