Original Spare Parts; Scope Of Delivery; Returns - Hettich Rotanta 460 R Mode D'emploi

3.6

Original spare parts

3.7

Scope of delivery

3.8

Returns

AB5650en
Use only original spare parts from the manufacturer and approved accesso-
ries.
The following accessories are supplied with the centrifuge:
■
1 grease for the trunnions
■
1 Hex key (5 mm x 170)
■
1 right-angled hex key (2.5 mm)
■
1 6-lobe (Torx) pin key wrench, short (T20 SG)
■
1 power cable
■
1 user manual
■
1 instruction sheet, transport lock
Additionally for device with nitrogen:
■
1 instruction sheet for nitrogen connection
■
1 cartridge application gun
■
1 silicone
Additionally for type 5675:
■
1 single-end open-ended spanner 10 mm AF
■
1 double-end open-ended spanner 17/19 mm AF
Additionally for delivery in Germany:
■
1 inspection book
Rotors and the corresponding accessories are supplied depending on the
order.
An original Return Material Authorisation (RMA) form from the manufacturer
must always be requested for a return. Secure and reliable acceptance and
booking in of the goods with the manufacturer is not possible without an
original RMA form from the manufacturer. The Return Material Authorisation
(RMA) form contains a Declaration of No Objection (UBE), which must be
completed in full and enclosed with the return.
If the device and/or accessories are returned to the manufacturer, the
complete return shipment must be cleaned and decontaminated by the
sender. If returns are not cleaned and/or decontaminated or are insuffi-
ciently cleaned and/or decontaminated, this will be performed by the manu-
facturer and charged to the sender.
The original transport locks must be attached for return shipment, see
Chapter 4 'Transport and storage' on page 22 . The device must be
⮫
shipped in its original packaging.
Rev.: 24 / 01.2024
Device overview
21 / 73