Lid With Screw Cap And Hole; Lid With Bracket And Spring-Type Lock - Hettich Rotanta 460 R Mode D'emploi

6.6.2

Lid with screw cap and hole

1
2
Fig. 29: Biosafety system
1 Rotary handle
2 Rotor
3 Lid
4 Key
Closing
Opening
6.6.3

Lid with bracket and spring-type lock

1 3
Fig. 30: Biosafety system
1 Bracket position "open"
2 Bracket opening operations
3 Bracket position "close"
4 Bracket carrying position
Closing
AB5650en
Biosafety systems must only be stored with the lid open to avoid damage to
the sealing rings during storage.
3
4
1. Place the lid (
2. Insert the supplied key (
3. Turn the lid (
1. Insert the supplied key (
2. Turn the lid (
3. Remove the lid (
2
4
1. Swivel the bracket to the "open" position (
The arrows of the labelling must point downwards so that the word
"open" is legible.
2. Place the lid centrally on the bucket.
The two pins of the lid must be in the two openings of the bracket
( 2 ).
3. Swivel the bracket to the "close" position (
The arrows of the labelling must point downwards so that the word
"close" is legible.
The bracket must rest on the bucket so that the bucket can swing out
during the centrifugation run.
Rev.: 24 / 01.2024
3 ) centrally on the rotor ( 2 ).
4 ) into the hole in the rotary handle ( 1 ).
3 ) at the key ( 4 ) clockwise until it is tightly closed.
4 ) into the hole in the rotary handle ( 1 ).
3 ) at the key ( 4 ) anticlockwise until it is open.
3 ) from the rotor ( 2 ).
Operation
1 ).
3 ).
37 / 73