Program Links; Linking Programs Or Changing A Program Link - Hettich Rotanta 460 R Mode D'emploi

7.7

Program links

7.7.1

Linking programs or changing a program link

AB5650en
[Rotary knob] to set 'off' or 'on' .
5. Use
off = disable automatic switch-off
on = automatic switch-off enabled
[START] button.
6. Press the
�� The setting is stored.
'Store Settings...' is displayed briefly.
'-> Settings' is then displayed.
[STOP/OPEN] button once to exit the 'Settings menu'
7. Press the
or
[STOP/OPEN] button twice to exit the 'Machine Menu' .
Press the
25 program links can be stored (program locations A to Z,
program location J does not exist).
A program link can consist of a maximum of 20 programs.
In a program link, the speed from one program to the next
is always adjusted with the ramp-up parameter of the next
program.
No centrifugation parameters can be changed in a program
link. Changing the parameters is only possible in the indi-
vidual programs.
No continuous operation programs or programs with ramp-
up and ramp-down times may be linked.
The [TIME] button can be used to retrieve the total runtime
of the program link and the runtime of the currently running
program during the centrifugation run.
Program links are enabled.
[PROG] button repeatedly until 'EDIT A...Z ' is displayed.
1. Press the
2. Use the [Rotary knob] to set the desired program location where the
program link is to be saved.
[START] button.
3. Press the
�� The program location of the program link and the first program of
the program link are displayed.
[Rotary knob] to set the first program of the program link.
4. Use the
[PROG] button.
5. Press the
�� The next program in the program link is displayed.
[Rotary knob] to set the next program of the program link.
6. Use the
[PROG] button.
7. Press the
�� The next program in the program link is displayed.
8. Repeat steps 6 and 7 until all programs are set.
[Rotary knob] to set 'END' . For this, turn the rotary knob anti-
9. Use
clockwise.
'END' can be set after the 20th program if the program links
No
consist of 20 programs.
Rev.: 24 / 01.2024
Software operation
61 / 73