Ryobi RIG2000PC Manuel D'utilisation page 39

230 V AC RECEPTACLES
Your generator has two single phase, 50 Hz outlets that
are 230 Volt AC, 15 Amp receptacles. These can be used
for operating appropriate appliances, electrical lighting,
tools, and motor loads.
AIR FILTERS
The air fi lters help to limit the amount of dirt and dust
drawn into the product during operation.
AUTO IDLE SWITCH
The auto idle switch is used to control the speed of the
engine and conserve fuel. When the switch is in the ON (I)
position and no appliances are connected to the product,
the engine will idle. If an appliance is added, the engine
speed will increase to power the item. If the appliance is
removed, the engine will return to idle.
BATTERY CHARGING CABLE
The battery charging cable makes it easy to charge 12
Volt lead acid batteries with the generator.
NOTE: Only use battery charging cable to charge vented
wet lead acid batteries.
CARRY HANDLES
The generator is equipped with two carry handles for
easy transport. Both handles should be used to carry the
generator.
DC CIRCUIT BREAKER
The circuit breaker is provided to protect the generator
against electrical overload.
DC RECEPTACLE
Your generator has a 12 volt, 7.5 Amp DC receptacle for
charging lead acid batteries.
ENGINE/CHOKE LEVER/ON-OFF
VALVE LEVER
The engine/choke lever/ on-off switch/fuel valve lever is
used when starting, stopping, and running the engine.
FUEL TANK
The fuel tank has a capacity of 3.8 L.
GROUND TERMINAL
The ground terminal is used to assist in properly grounding
the generator to help protect against electrical shock.
Consult with a local electrician for grounding requirements
in your area.
English (Original instructions)
LED DISPLAY
LEDs provide feedback to indicate whether the generator
is in use, overloaded, or in need of lubricant.
OIL CAP/DIPSTICK
Remove the oil fi ll cap to check and add oil to the generator
when necessary.
PARALLEL KIT TERMINALS
The non-polarized parallel kit terminals are used with a
parallel kit (sold separately) that will allow generators to
be linked together to increase output.
NOTE: Read and understand the parallel kit's instructions
prior to use. Kit is for usage with this product only.
RESET BUTTON
The reset button is used to restore power if an overload
occurs. To restore power, depress the reset button.
RETRACTABLE HANDLE
The generator is equipped with a retractable handle that
can be adjusted for storage and transportation.
STARTER GRIP AND ROPE
The starter grip and rope is used (along with the engine/
choke lever) to start the generator's engine.
ASSEMBLY
UNPACKING
The product has been shipped completely assembled.
■
SWITCH/FUEL
■
■
■
PACKING LIST
Generator
Battery charging cable
Engine lubricant (SAE 10W 30) (355 ml)
Screwdriver
Paper funnel
28
Remove one end of the box and carefully slide out the
generator and any accessories.
NOTE: The generator is heavy. If you must lift the
product out of the box, get another person to help you
and lift with your legs, not your back.
Inspect the product carefully to make sure no damage
occurred during shipping.
Do not discard the packing material until you have
care ful ly inspected and satisfactorily operated the
product.
If any parts are damaged or missing, please contact
your nearest authorised service centre for assistance.