Master; Main Inserts - Dynacord PowerMate 2200 Mode D'emploi

MASTER

49. MAIN INSERTS

Stereo phone jack for the left and the right channel with breaker function. The low
impedance output is assigned to the tip (send) and the high impedance input (return)
is assigned to the ring of the connector. This jack allows the connection of external
EQs, compressors, limiters, etc. into the master's signal path. The insertion point is
pre master faders. As well as with the inserts of the monaural input channels, different
DIRECT OUT functions can be accomplished.Please, also refer to the corresponding
section in the description of the MONO INPUTS.
50. MAIN OUTPUTS
The signals at the MAIN OUTPUTS are post master fader and mainly meant to feed
additional, external power amplifi ers. Through these outputs it is also possible to es-
tablish a two way active system set-up. In this case the active cross-overs – or active
active sub woofers – have to be connected to the MAIN OUTPUTS. If you want to use
the internal power amplifi er to supply the high frequency cabinets, the treble signal
coming from the cross over has to be fed back into the PowerMate via the POWER
AMP INPUTS.
51. EQ INPUTS / OUTPUTS
The EQ INPUTS are provided through electronically balanced phone jacks with brea-
ker function. When inserting a phone plug, the signal path is interrupted between the
master and the internal power amplifi er. The EQ INPUTS respectively the POWER
AMP INPUTS are then the only active inputs for the internal power amplifi er.The sig-
nals at the EQ OUTPUTS are post master fader and post the internal 7-band equali-
zers. Likewise, the MAIN OUTPUTS can be used for connecting external devices.
52. POWER AMP INPUTS
The POWER AMP INPUTS are also provided via electronically balanced phone jacks
with breaker function. When inserting a phone plug, the signal path gets split up bet-
ween the master and the internal power amplifi er. The POWER AMP INPUTS are then
the only active inputs for the internal power amplifi er.NOTE: For detailed information
on the functioning and the operation of the "MASTER PATCHBAY" – MAIN INSERTS,
MAIN OUTPUTS, EQ IN/OUTPUTS, and POWER AMP INPUTS – please refer to the
corresponding section; later in this owner's manual.
53. FX1/2 FOOTSW.
Phone jack for the connection of a DYNACORD FS11 foot switch, to switch the effect
mode of the internal FX units on or off.To accomplish this function, the switches FX1
and FX2 have to be engaged.
54. LAMP
This XLR-type socket provides a DC voltage
of 12V /2.4 watts and is meant for the connec-
tion of a gooseneck lamp. Please make sure
that the used lamp complies with the here
mentioned specifi cations and pin assignment.
Overload or short circuit can result in damaging
this output. To prevent this from happening, we
recommend the use of the gooseneck lamp
(112700), available from the DYNACORD
accessory assortment.For further information,
please consult your dealer.
46