Dynacord PowerMate 2200 Mode D'emploi page 54

STANDARD INSTALLATION
MAIN MIX
Position the master faders in the range between –30dB and –20dB.
• Establish a basic mix, using the channel faders, so that the individual sound levels relate to each other
according to your personal taste.
• The best range for the channel faders to be set to is in the area of –5dB to 0dB. In this way you are
provided with enough tolerance for later adjustments.
• Use the master faders to adjust the overall volume.
• In case you are using the FX units, please proceed like this:
1. Adjust the AUX1/FX1 send controls at their center position.
2. Adjust the FX1 return fader at the –5dB mark.
3. Use the UP/DOWN buttons to select the desired effect preset.
4. Press the FX ON button.
5. Play the sound source of the desired input channel and adjust the desired amount of the FX
signal, using the AUX/FX controls of this input channel. Repeat this step for all input channels
that you want to include in your effect mix.
6. Adjust the AUX/FX SEND controls, so that the Peak LED only lights frequently at highly
dynamic signal peaks.
If necessary, repeat steps 1 - 6 for the second internal FX unit (FX2).
MONITOR MIX
For now, we presume, that you are not using the PowerMate within the audience area but on-stage.
• Lower the setting of the AUX3 fader within the master section.
• Engage the AUX3 POST button within the master section.
• Adjust the AUX3 faders of all input channels that are momentarily in use at their center position. In this
way the main mix and the monitor mix are completely identical.
• Push the AUX3 fader up until a slight feedback noise is heard.
• Activate the FEEDBACK FILTER and adjust its control, so that the feedback disappears.
• Use the AUX3 fader to reduce the AUX3 level by about –6dB. This will provide you with enough
"headroom" to avoid feedback even during the performance, when some microphone positions are
changed disadvantageously.
• Use the FX to AUX3 control to add the effect mix to the monitor mix, without infl uencing the main mix.
Normally, the monitor mix needs a smaller amount of effect than the main mix.
Let the artists perform some and check the sound of the system from different angles and distances. If you come
to the conclusion that some corrections in the overall sound image are necessary, activate the 7-band equalizer
and match the sound to your liking. By doing so, you should keep in mind, that during the performance the sound
is going to be altered because the audience is present, which has a major effect on the acoustical condition of the
location, the degree of fi rst refl ections, and the absorption of low frequencies. If possible, you should check the
"sound in the house" during the performance and – if necessary – adjust it to the changed conditions.
And for the rest, we like to wish you lots of fun and success with your new PowerMate mixer.
54