Phones/Mono - Dynacord PowerMate 2200 Mode D'emploi

PHONES + MONO OUT + STAND BY
38. MONO OUTPUT
At the monaural output the summed L/R signal of the master is present. It can be used
for additional monitoring, side fi ll and "next door" applications, or to establish a delay-
line.
CAUTION: The outputted signal is not only affected by the setting of the MONO
OUT fader but also by the MASTER faders' setting.
39. PHONES OUTPUT
Stereo phone jack for the connection of headphones with an impedance of 32 – 600
ohms. The audio signals of the channels where the PFL button is engaged is outputted
via this connector.
40. PHONES LEVEL
This control is used to adjust the headphone's volume.
CAUTION:
Adjust this control at its minimal setting before connecting the headphones.
41. STANDBY
Pressing the STANDBY button mutes all outputs to which amplifi ers could be connec-
ted to the PowerMate. Because the signal fl ow between the MAIN INSERTS and the
MAIN OUTPUTS is interrupted, the internal power amplifi er's signal is also muted. The
STANDBY LED indicates that the stand-by mode is engaged and the input channel
signals are not heard over the speaker systems. But, the 2Track Return signal is still fed
to the power outputs, providing you with a very comfortable solution to play intermission
music during performance breaks.
42. MONO MASTER VOLUME
This fader controls the output level of the MONO OUTPUT. The output level is also
infl uenced by the setting of the MASTER faders (post fader).
In case a PRE FADER signal split would provide the better solution for your application,
this can be achieved by some minor internal changes.
Please consult your dealer for assistance.
44