Setting Up The Transmitter; Inserting The Batteries/Rechargeable Batteries - Reely SKY R222 Notice D'emploi



9. Setting Up the Transmitter

In the operating instructions, the numbers in the text always refer to the figure opposite or the figures within
the section. Cross-references to other figures will be indicated by the corresponding figure number. Upon
delivery, the transmitter is set to mode II.
a) Inserting the Batteries/Rechargeable Batteries
For the power supply of the transmitter you will need 8 alkaline batteries (e.g. Conrad Item No. 652507, pack of 4,
order 2) or rechargeable batteries mignon size (AA). For ecological and also for economical reasons it is recom-
mended to use rechargeable batteries, since they can be recharged in the transmitter via a built-in charging socket
(see figure 2 item 17). To insert the batteries or rechargeable batteries, proceed as follows:
The battery compartment lid (1) is located on the back of
the transmitter. Lift the lid in the middle of the lower edge
and fold it open upwards.
Remove the battery holder (2) and place 8 batteries or re-
chargeable batteries in the battery compartment. Always
make sure the polarity of the batteries is correct. A corre-
sponding indication (3) is located at the bottom of the bat-
tery compartment.
Once you have inserted the full battery holder back into the
remote control close the lid of the battery compartment and
let the locking mechanism click into place.
Important!
The battery holder has two snap-in pins (4) which must point upwards when the holder is inserted so that
they can snap into the battery compartment guides.
The battery compartment is fitted with a polarity protected BEC plug-in connector (5) which is connected
inside the transmitter battery compartment. It is not usually necessary to remove the plug when inserting
batteries or rechargeable batteries.
All manuals and user guides at all-guides.com
Figure 3
53