Before Use; Avant L'utilisation; Précautions Et Sauveguardes Importantes - Teac PL-D2000 Manuel Du Propriétaire

Table des Matières

Publicité

CAUTION Regarding Placement
To maintain proper ventilation, be sure to
leave a space around the unit (from the
largest outer dimensions including
projections) equal to, or greater than,
shown below.
Left and Right Panels
Rear Panel
Top Panel
6
Important Safeguards and
Precautions
Power Cord Protection
To avoid any malfunctions of the unit, and to
protect against electric shock, fire or
personal injury, please observe the
following:
< Hold the plug firmly when connecting or
disconnecting the AC power cord.
< Keep the AC power cord away from the
heating appliances.
< Never put any heavy object on the AC
power cord.
< Do not attempt to repair or reconstruct the
AC power cord in any way.
Location and Handling
< Air vents are provided in the cabinet to
prevent excessive tempratures inside the
unit. Do not place this unit in closed
spaces, cover it, or otherwise block the
vents.
< The ventilation holes should not be
covered. Make sure there is at least 50 cm
: 10 cm
of space above and at least 10 cm of
: 10 cm
space on each side of this unit. Do not
: 50 cm
place a CD player or other equipment on
top of this unit.
< Do not place this unit in direct sunlight, or
near heat sources.
< Keep this unit away from strong magnetic
objects.
< Do not insert or drop anything into this unit
through the air vents as this could cause
serious damage, possibly resulting in fire.
< Do not place any object containing water
or other liquids on this unit. In the event
that liquid should enter the cabinet,
unplug this unit immediately and contact
the retailer or service centre immediately.
< Do not remove the cabinet. Touching parts
inside the cabinet could result in electric
shock and / or damage to the unit.
< Do not use the unit in a car. The operation
can not guaranteed.
< This unit generates heat during operation.
Do NOT place anything on top of this unit.
< Place the unit in a horizontal position, and
do not place anything heavy on it.
Nonuse Periods
< When the unit is not being used, turn the
unit off.
< When left unused for a long perid of time,
the unit should be unplugged from the
household AC outlet.
No Fingers or Other Objects Inside
Do not put any foreign object on the disc
tray.
This unit has a lot of LSI (Large Scale
Integration) devices and ICs (Integrated
Circuits) inside; and on rare occasions it
malfunctions because of static electricity,
electric noise, irregularities in the power
supply, etc.
If something goes wrong with the unit, we
suggest turning it off and on again.

Before Use (1)

ENGLISH

Avant l'utilisation (1)

Précautions et sauveguardes
importantes
Protection du cordon d'alimentation
Afin d'éviter tout mauvais fonctionnment de
l'appareil et pour une protection contre des
chocs électriques, feu ou blessures, veuller
suivre les consignes suivantes:
< Tenir la prise fermement quand vous
branchez ou débranchez le cordon
d'alimentation
< Tenir le cordon d'alimentation loin de source
de chaleur
< Ne jamais placer un object lourd sur le
cordon d'alimentation
< Ne pas essayer de réparer ou reconstruire
le cordon d'alimentation de n'importe qu'elle
façon.
Emplacement et manutention
< Le cabinet est muni de fentes de ventilation
afin de prévenir une hausse excessive de
température à l'intérieur du cabinet. Ne pas
placer cet appareil dans des espaces
constraints, le couvrir ou boucher les fentes.
< Les trous de ventilation ne doivent pas être
couverts. S'assurer qu'il y a un espace d'au
moins 10 cm au dessus et un espace d'au
moins 50 cm à côté de cet appareil. Ne pas
placer un lecteur CD ou un autre appareil sur
le dessus cet appareil.
< Ne pas exposer cet appareil aux rayons
solaires directs, ou près de sources de
chaleur.
< Tenir éloigner d'objets magnétisés
puissants.
< Ne pas insérer ou échapper quelque chose
dans cet appareil à travers les fentes, cela
peut occasionner des dommages sérieux et
peut-être des incendies.
< Ne jamais placer un object contenant de
l'eau ou d'autre liquides sur cet appareil. Si
un liquide pénètre l'appareil, le débrancher
immédiatement
et
contacter
dépositaire ou dépot de service.
< Ne pas enlever le cabinet. Si vous touchez
des pièces à l'intérieur du cabinet, vous
risquez un choc électrique et / ou
d'endommager l'appareil.
< Ne pas utiliser cet appareil dans une
automobile. Son opération n'est pas
garantie.
< Cet appareil produit une chaleur quand il est
en fonction. Jamais placer quelque chose
sur le dessus.
< Installer l'appareil dans une position
horizontale et ne pas mettre aucun object
pesant au dessus.
Période de non-utilisation
< Si l'appareil n'est pas utilisé, l'éteindre
< Si l'appareil n'est pas utilisé pour une
période prolongée, le débrancher.
Aucun object ou doigts à l'intérieur
Ne pas déposer aucun object sur le tirroir du
disque
Cet appareil est équipé de composants LSI
(large scale integration: intégration à
grande échelle) et IC (circuit intégré)
incorporés; et il est possible que rarement il
ne se comporte pas comme il faut à cause
d'une charge statique, d'un bruit électrique,
d'une irrégularité de l'alimentation de
courant, etc.
Si quelque chose ne semble pas aller bien,
mettre l'appareil hors tension et ensuite le
remettre sous tension.
FRANÇAIS
votre

Publicité

Table des Matières
loading

Table des Matières