Teac PL-D2000 Manuel Du Propriétaire page 50

Table des Matières

Publicité

1
2
3
4
50
Basic Setup (6)
Height
< The best height for the front speakers is
when the high frequency speakers
(tweeters) are at ear height (while
seated).
< The best height for the center speaker is
at the height of your ears (while seated)
< The height of the rear speakers is not less
than the height of your ears (while
seated).
See the diagram. You'd better place the
rear speakers in the D area. You can
place them in the C area, too.
Size
When you do not connect center, rear
speakers or subwoofer, set the parameters
for them in the SETUP MENU. Since the front
speakers setting are fixed, you cannot
change them.
ON: Normally select this.
OFF: If you will not connect the relevant
speaker(s), select this.
Note
< When BASS MODE in the SETUP MENU is
set to CONFIG 1, you cannot select the
SUBWOOFER. (see page 94)
1 Press the SETUP button to enter SETUP
MENU. Use the 5/b buttons to select
SPEAKER SETUP, and then press the
ENTER button.
2 Highlight CENTER using the 5 /b
buttons, then press the tbutton to go to
the right option list. Select ON or OFF
using the 5 /b buttons, then press
ENTER to confirm your selection.
3 Highlight REAR using the 5/b buttons,
then press the tbutton to go to the right
option list. Select ON or OFF using the
5 /b buttons, then press the ENTER
button to confirm your selection.
4 Highlight SUBWOOFER using the 5/b
buttons, then press the t button to go to
the right option list. Select ON or OFF
using the 5/b buttons, then press the
ENTER button to confirm your selection.
5 Press SETUP again to exit menu.
ENGLISH
Réglage de base (6)
Hauteur
< La hauteur idéale pour les haut-parleurs
avants est quand les tweeters sont au
niveau de l'oreille (quand assi). La hauteur
idéale pour le haut-parleur du centre est à
la hauteur de vos oreilles (quand assi).
< La hauteur des haut-parleurs arrières
n'est pas moin que la hauteur de vos
oreilles (quand assi).
< Voir le diagramme. Il est préférable de
placer les haut-parleurs arrières dans la
section D. Vous pouvez aussi les placer
dans la section C.
Dimension
Si vous ne branchez pas le haut-parleur du
centre, les haut-parleurs arrières ou le
subwoofer, régler leur données dans le
menu SETUP. Vu que les haut-parleurs avant
sont fixes, vous ne pouvez pas les changer.
Les réglages par défaut sont soulignées.
ON: Normalement choisir ce réglage
OFF: Si vous ne branchez pas le(s) haut-
parleur(s) relevant(s), choisir ce
réglage
Remarque
< Si BASS MODE dans le menu SETUP est
en position CONFIG 1, vous ne pouvez pas
choisir l'option SUBWOOFER. (voir page
94)
1 Appuyer sur la touche SETUP pour
engendrer le menu SETUP. Utiliser les
touches 5 /b pour choisir SPEAKER
SETUP et ensuite appuyer sur la touche
ENTER.
2 Rehausser CENTER utilisant les touches
5/b, ensuite appuyer la touche t pour
aller vers la liste d'option de droite.
Choisir ON ou OFF utilisant les touches
5 /b , ensuite appuyer sur la touche
ENTER pour confirmer votre choix.
3 Rehausser REAR utilisant les touches
5 /b , ensuite appuyer sur la touche
t pour aller vers la liste d'option de
droite. Choisir ON ou OFF utilisant les
touches 5/b, ensuite appuyer ENTER
pour confirmer votre choix.
4 Rehausser SUBWOOFER utilisant les
touches 5/b, ensuite appuyer sur la
touche t pour aller vers la liste d'option
de droite. Choisir ON ou OFF utilisant les
touches 5 /b ensuite appuyer sur
ENTER pour confirmer votre choix.
5 Appuyer sur la touche SETUP de nouveau
pour quitter le menu.
FRANÇAIS

Publicité

Table des Matières
loading

Table des Matières