Important Safety Instructions - Teac PL-D2000 Manuel Du Propriétaire

Table des Matières

This product has been designed and manufactured according to

FDA regulations "title 21, CFR, chapter 1, subchapter J, based on the

Radiation Control for Health and Safety Act of 1968", and is

classified as class 1 laser product. There is not hazardous invisible

laser radiation during operation because invisible laser radiation

emitted inside of this product is completely confined in the

protective housings.

The label required in this regulation is shown

CAUTION

< DO NOT REMOVE THE PROTECTIVE HOUSING USING

SCREWDRIVER.

< USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF

PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY

RESULT IN HAZARDOUS RADIATION EXPOSURE.

< IF THIS PRODUCT DEVELOPS TROUBLE, MAKE A CONTACT WITH

OUR SERVICEMAN, AND DO NOT USE THE PRODUCT IN A

TROUBLED STATE.

For U.S.A.

TO THE USER

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These

limits are designed to provide reasonable protection against interference in a residential area. This device generates and uses radio

frequency energy and if not installed and used in accordance with the instructions, it may cause interference to radio or TV reception. If

this unit does cause interference with TV or radio reception you can try to correct the interference by one or more of the following

measures :

a) Reorient or relocate the receiving antenna.

b) Increase the separation between the equipment and the receiver.

c) Plug the equipment into a different outlet so that it is not on the same circuit as the receiver. If necessary, consult the dealer or an

experienced radio/TV technician for additional suggestions.

CAUTION

Changes or modifications to this equipment not expressly approved by TEAC CORPORATION for compliance could void the user's authority

to operate this equipment.

For CANADA

AC POWER CORD CONNECTION

CAUTION:

TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG

TO WIDE SLOT, FULLY INSERT.

WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

THE LIGHTNING FLASH WITH ARROWHEAD SYMBOL, WITHIN AN EQUILATERAL TRIANGLE, IS INTENDED TO ALERT THE USER TO THE

PRESENCE OF UNINSULATED "DANGEROUS VOLTAGE" WITHIN THE PRODUCT'S ENCLOSURE THAT MAY BE OF SUFFICIENT MAGNITUDE TO

CONSTITUTE A RISK OF ELECTRIC SHOCK TO PERSONS.

THE EXCLAMATION POINT WITHIN AN EQUILATERAL TRIANGLE IS INTENDED TO ALERT THE USER TO THE PRESENCE OF IMPORTANT

OPERATING AND MAINTENANCE (SERVICING) INSTRUCTIONS IN THE LITERATURE ACCOMPANYING THE APPLIANCE.