Important Directions - La Pavoni EUROPICCOLA Mode D'emploi

English
Warning: don't put your hands under the Cappuccino Automatic, because the
overheated liquid may cause scalds.
13 – IMPORTANT DIRECTIONS
Place the machine on a stable and dry surface, away from heat sources and to the
reach of children.
Regularly check the amount of water contained in the boiler through the glass level (5);
the lack of water when the machine is working may cause the heating element to burn
out, even if the machine is equipped with a safety thermostat.
When the machine is on, heats the water and produces steam, which remains com-
pressed inside the boiler. For safety reasons, it is recommended to take the machine out
of reach of children and not to touch hot parts such as the boiler (9), the unit (11) and
the filter-holder (10), to avoid burns and possible scalds.
Do not remove the filter-holder and do not absolutely put your hands under the unit
during the deliver y, to avoid possible scalds.
Do not open the boiler cap (3) when the machine is working or still under pressure,
to avoid possible burns.
To screw the cap off and refill the boiler, place the switch (6) on the OFF position, slowly
turn the steam tap knob (4) anticlockwise to open it, and wait for all the steam contai-
ned in the boiler to be discharged by the pipe provided (12); in case the steam does
not come out properly, remove the filter-holder (10) and slowly lift the lever (1); hold
the lever up to allow the steam and water contained in the boiler to be discharged
through the unit.
In both cases, it is advisable to use a container for steam and water collection, paying
attention since the steam and water discharged are overheated and may cause scalds.
When the steam and water stop discharging, unscrew the boiler cap slowly.
When the machine is off, during the process of cooling down, it may happen that the
lever moves upward by itself. This phenomenon is caused by the depression forming
inside the boiler itself.
If the machine is not used often, switch it off, placing the ON/OFF switch on the OFF
position and removing the main cable plug from the socket without pulling it.
„†