Electric Connection; Commissioning - La Pavoni EUROPICCOLA Mode D'emploi

English
5 – ELECTRIC CONNECTION
Warning! Before making the electric connection, make sure that the main power vol-
tage corresponds to the specifications indicated on the data plate placed under the
base of the machine.
6 – COMMISSIONING
picture A
picture B
picture C
- Unscrew the cap ( 3) of the boiler anticlockwi-
se, picture A.
- Prepare a water solution with two teaspoons
of bicarbonate in a container and wait for the
bicarbonate to dissolve completely; then pour
the solution into the boiler (9).
Alternatively, instead of using bicarbonate,
prepare in a container a solution of water
with a tablespoon of white vinegar and pour
it into the boiler.
- Make sure that the lever (1) is down; even-
tually pull it down completely, picture C.
- Screw the cap (3) into the boiler by turning it
clockwise and make sure that the cap and the
steam tap knob (4) are properly closed (turn
clockwise), picture B.
- Fit the filter-holder (10) into the unit (11) and
fix it by moving it from right to left, picture H.
- Insert the main cable plug into an electric
socket with adequate voltage (please refer to
the plate under the base of the machine), pic-
ture C.
- Place the switch (6) on the ON position and
wait for the machine to reach the required
pressure (about 5 minutes), place a container
under the unit (11), slowly lift the lever (1)
completely and hold it in this position so as to
fully discharge the water contained in the boi-
ƒˆ