Insertion Of Nation Key; First Switching On; Serial Port Connection - La Pavoni BAR AT ES Mode D'emploi

la Pavoni
Important
It strongly suggested that the machine be supplied with
water treated through a descaling device, especially
in cases of water with a high content of calcium and
magnesium salts (hard water).
5 . 2 5 . 2 5 . 2 5 . 2 5 . 2

Insertion of Nation key

Insertion of Nation key Insertion of Nation key Insertion of Nation key Insertion of Nation key
Danger
Operation falling within the competence of the
Maintenance technician.
The "nation key" contains the following data:
- Langua ge sho wn on displa
- Setting of software according to the Country where the
machine is utilised.
Important
The machine WILL NOT operate without the "nation
key", so it is important to see to this operation.
The machine will only accept a single insertion of the
"nation key".
To inser t the na tion k ey it is necessar
operations be performed:
- Di s connect el e ctri c al po
- Dismantle the left-hand side panel (ref. 1, fig. 1) and the
glass (ref. 2, fig. 1).
- Inser t the k ey (r ef. A, fig . 9) into the connector (r
9) of the electronic board.
- Re-assemble the glass and the side panel..
C
A
fig. 9
y.
y tha t the f ollo wing
wer.
ef. B, fig .
B
5 . 3 5 . 3

First switching on

First switching on
5 . 3 5 . 3 5 . 3 First switching on First switching on First switching on
- Fill the cof fee hopper (r ef. 7, fig . 1) with the selected cof-
fee bean blend.
mportant
Make sure that the coffee beans don't contain foreign
bodies (pebbles, metallic elements or whatever) which
could damage the grinders.
- Mak e sur e tha t the all mac
(ref. 15 and 17, fig. 1) are in place and that the front door is
closed (ref. 13, fig. 1).
On the contr ar y, w hen the mac
splay (ref. 8a, fig. 1) will show which of the components is
at faul t .
- Connect the machine to the mains (either by setting the
all-pole switch to "I" or by plugging).
- Switch machine on by way of the main switch (ref. 10, fig.
1);
The displa y will sho w messa ge "HEA TING WAIT".
- When the display shows "READY FOR USE", it will be
necessary to:
- Position the dispenser (ref. 23 and 24, fig. 1) so as to obtain
a height suita ble f or the container
dispenser unit").
- Position one or tw o container
- Press the key corresponding to the type of drink selected.
Important
Even though initially all keya are programmed with
standard values, it is necessary to check that the drink
dispensed corresponds
characteristics. If this is not the case, set again the
dispensing keys (see "6.14 Programming of dispensing
keys").
5 . 4 5 . 4 5 . 4 5 . 4 5 . 4

Serial port connection

Serial port connection Serial port connection Serial port connection Serial port connection
Danger
Operation falling within the competence of the
Maintenance technician.
Beside the "nation key" connector the RS 232 serial port (ref.
C, fig. 9) is found.
Through this serial port it is possible to connect the machine
to the de vices and equipment de
SERVICE CENTRES f or tests and pr
Engl i s h
hine' s r emo vable components
hine s witc hes on, the di-
s in use (see "4.3 Cof
s under the dispenser .
with the desired
plo yed b y the AUTHORISED
ogramming oper ations .
fee
37